Sign in to follow this  
Followers 0
Purdy Bear

Free spinning wheel plans

4 posts in this topic

I hope this is ok being separate, I wasnt sure wether to put it with the other one. Anyhow, Iv found this website, that shows you how to make your own spinning wheel. It gives the final construction, takes it to bits and shows each peice assembly and then gives drawings for each part. (NB you need to scroll down to find the plans).

 

 

 

 

 

 

http://www.craftsmanspace.com/free-project...wheel-plan.html

Share this post


Link to post
Share on other sites

Pretty, but have you seen one that uses a bicycle wheel, and maybe some other bicycle parts? That's the one I've been looking for.

Share this post


Link to post
Share on other sites

My grandfather made quite a few spinning wheels. He made several using the bases of old treadle sewing machines. You can use the wheel-shaped guides inside the housing for the sewing machine head to hold the drive band, exactly like you would for a sewing machine head. You need a plank, piece of counter top, plywood, get creative, etc. with an oblong hole for the drive band to pass through and around the drive shaft of the spinning head on the "table top". Grandfather did machine his own heads and bobbins, but one could just as easily salvage a head and supports from an old wheel instead.

 

If you use this idea, make sure you choose a spinning head that is not wobbly (or bobbly :D ). Make sure the pieces of wood supporting the head are thick enough you can put a decent size screw into them or you won't have something that will endure the vibration of your machine doing it's work. It is a good idea to drill a small, starter hole into the wood and then sink a slightly larger screw, so you don't split the wood and wreck your head set-up. Also, make sure that you have a number of bobbins or can still get them new. Three is mandatory, six is better. You can buy the drive band material by the yard on the Net.

 

Grandpa's were elegant looking, but this really is a work-horse idea. If you need to get the work done in a pinch, something like this could be made very quickly (if you've already got the parts) and without a lot of hoo haw. The idea works well.

 

It is also very possible that a somewhat knowledgeable person could make a set up where the sewing machine head could be removed, table top "insert" be set in the hole where the head sits/hides, spinning table/head put in and the whole deal could work like an "attachment" without messing with the integrity of the sewing machine usage at all.

Share this post


Link to post
Share on other sites
Guest
You are commenting as a guest. If you have an account, please sign in.
Reply to this topic...

×   You have pasted content with formatting.   Remove formatting

  Only 75 emoticons maximum are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

Loading...
Sign in to follow this  
Followers 0